Loctite® Super Glue Gel Control™

No Drip, Easy Application

Porous surfaces and vertical applications. No-drip Gel formula in pin-point Control™ applicator.

Overview

Loctite Super Glue Gel Control has proven superior performance over ordinary super glues. It works faster and holds stronger on more surfaces than ordinary instant adhesives thanks to a patented additive. The gel formula works on a variety of porous and non-porous surfaces and is ideal for vertical applications. Loctite Super Glue Gel Control comes in patented side-squeeze design for maximum control. It dries clear and sets without clamping. Loctite Super Glue Gel Control is resistant to moisture, most chemicals and freezing temperatures.

Recommended For

Features & Benefits

Feature

Benefit

Gel formulation

Ideal for vertical repairs & No Dripping

Dries clear

Invisible repairs

Sets in seconds

No clamping required

Easy squeeze grips

Precision application

Directions for Use

Safety Precautions

Use in a well-ventilated area. Protect work area before and during use of the glue. Nitrile gloves and apron recommended. Do not use PVC, nylon, or cotton gloves. Skin contact may cause burns. Wash hands after use.
Fingers Bonded? Apply cooking oil to bonded area of skin. Gently message bonded fingers back and forth to ''peel'' apart. Use rolling, peeling motion – do not pull. Once apart use high moisture hand lotions to aid ion removal of excess glue from skin.

Preparation

Surfaces to be bonded must be close fitting, clean, dry and free from oil, wax and paint. Protect work area. For best results, lightly roughen smooth surfaces. Pre-fit parts to be joined.

Application

Note: Take care to not press in on the side wings while opening the container as glue may dispense rapidly. In a clockwise direction, screw the closure cap tightly in to the base until the clicking sound stops. Unscrew the cap in a counter clockwise direction. Press side grips to dispense one drop per square inch of surface. Press surfaces together immediately. Hold in place for 15 to 30 seconds until bond sets. Do not reposition parts. Clean tip with tissue and replace the cap screwing it down tightly in a clockwise direction. For increased strength, leave bond undisturbed for at least 10 minutes. Full cure in 24 hours.

Cleanup

After cleaning, wet any tissue used for wiping off glue with water and dispose of. When cleaning up larger quantities of uncured adhesive, apply water and allow to cure and then scrape up. Note this may result in damage to the surfaces. Cured adhesive may be cut away with caution using a sharp blade, removed with acetone or with boiling water. Note: Acetone may damage some plastics and is also highly flammable. Test before use and follow manufacturer's instructions.